Results 1 to 4 of 4

Thread: XTL cable

  1. #1
    Join Date
    Oct 2012
    Location
    Hanover PA
    Posts
    58
    Thanks
    29
    Thanked 0 Times in 0 Posts
    Country: Aruba

    XTL cable

    I’m getting ready to install my new XTL’S and was wondering if either of these cables will work for a remote install. I understand the one cable has an RS-232 connector and the other doesn’t. I have that cable already because it was listed as being for programming the radio. (But thus far I can’t get it connected to the PC.)

    https://rover.ebay.com/rover/0/0/0?m...2F151536065719

    So I was looking for a cable for the second radio and found this.

    https://rover.ebay.com/rover/0/0/0?m...2F151487725572






    Will the both work for my install?

    Thanks / Rob W1RRL
    Last edited by W1RRL; 01-12-2018 at 01:36 AM.


  2. #2
    Join Date
    Mar 2016
    Location
    Beside myself
    Posts
    100
    Thanks
    90
    Thanked 132 Times in 66 Posts
    Country: United States
    https://shopwiscomm.com/HKN6169B-HKN...RoCK2QQAvD_BwE

    https://m.ebay.com/itm/NEW-Motorola-...4AAOxyeZNTRPFg

    This is all you need for a remote mount XTL install. Assuming your using an 05 head. And assuming you already have the power cables for the brick.

    The second cable you linked in your post would work for a dash mount install. The programming cable could possibly work for a dash mount install if it were modified. But not for a remote mount set up.

    Sent from my HTC One A9 using Tapatalk
    Last edited by clbsquared; 01-12-2018 at 06:54 AM.
    "My mind is a raging torrent, flooded with rivulets of thought cascading into a waterfall of creative alternatives".

  3. #3
    Join Date
    Jan 2013
    Location
    In Your Network
    Posts
    2,308
    Thanks
    1,445
    Thanked 1,224 Times in 628 Posts
    Country: United States
    The rear connector on the XTL is only present on mid power radios. The radio supports both serial and USB rear programming cables (USB above certain firmware versions). You can program a remote or dash mount XTL from the preferred location using the GCAI programming cable (mic connector) or from the TIB on either W or O series TIBs.
    Retarded Mongoloid on PCP...

  4. #4
    Join Date
    Oct 2012
    Posts
    340
    Thanks
    42
    Thanked 29 Times in 19 Posts
    Also be careful cause there are combinations of housing/cables that wont work


    Sent from my iPhone using Tapatalk