Results 1 to 6 of 6

Thread: XPR4500 auto power on?

  1. #1
    Join Date
    Nov 29, 2012
    Location
    NC
    Posts
    50
    Thanks
    4
    Thanked 0 Times in 0 Posts

    Default XPR4500 auto power on?

    What pins do you have to jump so the XPR4500 will power back up when the public power goes off and back on. I have pins 7&9 jumped on my CDM1550LS+'s so they will power up automatically.

    Thanks
    SD70MAC out


  2. #2
    Join Date
    May 09, 2012
    Posts
    157
    Thanks
    14
    Thanked 27 Times in 18 Posts

    Default

    Just hook up ignition sense input. Sorry I don`t know what pin that is on a XPR

  3. #3
    Join Date
    Dec 12, 2011
    Location
    Avalon
    Posts
    1,210
    Thanks
    298
    Thanked 328 Times in 160 Posts
    Country: United States

    Default

    I think it is 25, it should be in the install manual.

  4. #4
    Join Date
    Aug 06, 2012
    Location
    Ontario, Canada
    Posts
    691
    Thanks
    135
    Thanked 228 Times in 114 Posts
    Country: Canada

    Default

    Correct, it is 25.

  5. #5
    ohiodesperado No Longer Registered

    Default

    Also, remember to set the codeplug to follow ignition sense and power button.
    Do NOT make the mistake of setting the radio to Ignition Sense only if you don't have an Ignition sense wire connected. The radio WILL NOT power on in this configuration without the Ignition sense. Trust me I have a customer with 200 radios that are configured that way because the GPS tracking system they use has an external interface module that controls the radio ignition sense. When the radios hit the bench, it the tech is not aware of it, they get a bit confused.

  6. #6
    Join Date
    Aug 06, 2012
    Location
    Ontario, Canada
    Posts
    691
    Thanks
    135
    Thanked 228 Times in 114 Posts
    Country: Canada

    Default

    I've acquired a few radios over the years that people thought were bricked because they programmed the ignition sense thay way