Communications Support Forums
My new program/cpg for my XTS2500 has picked up an issue where when it plays/rx's a channel from a separate zone/scan group it beeps at the start of every transmission. This gets annoying after a bit.
I've tried to replicate it by including other channels not in the same zone or scan group but they won't beep. I've looked through my options everywhere and cannot find the offender. It's just a simple soft beep every time it stops on something.
There's nothing obvious that I can see and I don't remember it doing this before programming on scan. ATM my pain killers are seriously fogging my ability to see/comprehend as well which is not helping.
So hoping it's something simple. TIA.
I've tried to replicate it by including other channels not in the same zone or scan group but they won't beep. I've looked through my options everywhere and cannot find the offender. It's just a simple soft beep every time it stops on something.
There's nothing obvious that I can see and I don't remember it doing this before programming on scan. ATM my pain killers are seriously fogging my ability to see/comprehend as well which is not helping.
So hoping it's something simple. TIA.