• If posting about a radio issue: Include the HOST, DSP and UCM/secure firmware versions, flashcode and CPS version you're using along with the operating system info. This is critical information.

Drag & Drop in TRBO CPS 11.2

Status
B

Blackwater

Not Registered
Picked up a XPR 7550 and was going to add to the codeplug and I can't seem to get the drag and drop to work in TRBO CPS. Has anyone had any issues? When I try to drag from one to another I get a red circle with a line through it.
 
P

Paulie

Contributing Member
Joined
Oct 16, 2015
Messages
30
Try to copy and paste should work

Things you can copy and past are

General settings
Security settings
Contacts
Zones

Things you cant copy and past

RX listings
Scan
Roam

not sure about any of the capacity plus stuff.
 
rainbowpenguin

rainbowpenguin

Prolific Contributor
CS Forums $upporter
Joined
Mar 13, 2015
Messages
104
Channels will copy and paste, frequencies and tones will copy fine, but all their settings (tx contact, scan list, rx group list, data revert channel, etc) sometimes don't copy. Depends on what info is already in the codeplug. Capacity plus channels will copy; the same above applies.
 
com501

com501

Prolific Contributor
CS Forums $upporter
Joined
Jan 18, 2013
Messages
2,845
You should ALWAYS double check every setting anyway as sometimes things don't always paste the way you think they should. When doing large codeplugs (my personal radios have 30+ zones and 40+ roam lists and as many scan lists) I always start at the top, c/p then start from the bottom and go the other way again.
 
OP
B

Blackwater

Not Registered
I believe I have the issue figured out. I'm opening two CPS's and trying to drag across. It appears you have to have both codeplugs open in one CPS. Can't have two open like in APX/XTS CPS
 
Status