• If posting about a radio issue: Include the HOST, DSP and UCM/secure firmware versions, flashcode and CPS version you're using along with the operating system info. This is critical information.

HT1000 recase issue

Status
Not open for further replies.

SD70MAC

Contributing Member
Joined
Nov 29, 2012
Messages
50
I recased an OLD HT1000 with a New case I have ,but it's missing the small spring loaded plug in the accessory connector. I have a box of old cases to rob one from ,but how do you get it out ?


These are the parts from the service manual;

3205160W01 SEAL

2205159W01 PIN

Both are listed as Actuator for S101
 
W

Will

Guest
Hi there, MAC. You only need that plunger actuator if you use the P. S. speaker mic with the antenna on it. It switches the radio over to the ext antenna contacts on the side connector. The plunger pops out of the housing.
 
OP
SD70MAC

SD70MAC

Contributing Member
Joined
Nov 29, 2012
Messages
50
Hello Will ,I will have to see if I can force one out of an old case. I may just seal it shut ,I don't need that option.

Thanks
 
Status
Not open for further replies.