• If posting about a radio issue: Include the HOST, DSP and UCM/secure firmware versions, flashcode and CPS version you're using along with the operating system info. This is critical information.

MCS2000 RX audio out vs Maxtrac RX audio out

dtbuff88

Regular Member
Joined
Mar 20, 2021
Messages
9
When I interface my maxtrac to my repeater controller it passes clean and clear audio to the controller and out the transmitter... however when I connect a mcs2000 using pin 11 I get nothing out of the transmitter but a dead key. When i connect pin 25 I get static. I remember on my maxtrac I had a Jumper that I had to reposition to get audio to pass. Is there a similar jumper on the mcs2000 that im missing or a setting in the software?

The MCS2000 is a 110W VHF model.
 

xpr8300

Prolific Contributor
CS Forums $upporter
Joined
Mar 1, 2012
Messages
725
What pin on the 16 pin maxtrac connectors are you pulling audio from and same with pins on the MCS DB25?