XG-100P Power Up To First System

[38258]

Noticed a quirk with a Unity I have. Upon power up, radio defaults to the first system listed in the mission plan. Occasionally it will power up to last used system/group. It will work with a mission plan but after editing and writing, it will stop booting to last used zone. I may bake some updates to mission plan and then it will work again. When powering up I will occasionally hear a double beep and then it boots to first system in the plan. Anybody experience this and or have a solution? Currently running firmware R06M03 but same result with previous revisions.

 

[38258]

Further, there is no error indication on the display as one would see if there was something like say a key missing etc. Unable to find anywhere in RPM14 to enable or disable this.

 

[Forts]

The startup system is defined in Options - Power Up Options. Have you set anything there?

 

[38258]

The startup system is defined in Options - Power Up Options. Have you set anything there?

Default as I do not see a selection for the last used system/group.

 

[TRS]

With the XG-100P,the selector knob assignments will usually override any of those settings.

 

[38258]

With the XG-100P,the selector knob assignments will usually override any of those settings.

In this case, 3 beeps when powered up and defaults to first system/group. No warnings displayed.