• If posting about a radio issue: Include the HOST, DSP and UCM/secure firmware versions, flashcode and CPS version you're using along with the operating system info. This is critical information.

XPR 2500 Mic Connector Pinout

Status
Forts

Forts

Prolific Contributor
CS Forums $upporter
Joined
Aug 6, 2012
Messages
857
Anyone happen to have the pinout for the mic connector on an XPR 2500? I'm looking to homebrew a programming cable since it'll be a pain to get to the rear accessory port once the radio is mounted in my Jeep. I'm assuming it's just a straight USB connection like the rear (hoping so at least). I have a copy of the BSM but it wasn't of any help.

Thanks!
 
Mars

Mars

Prolific Contributor
CS Forums $upporter
Joined
Dec 21, 2011
Messages
4,993
This may not be helpful as it doesn't have the microphone connector pinout, but attached is the 2500 installation guide, which has the rear pinout on page 32. You could always build your own USB cable and have it tucked under the dash.
 

Attachments

  • XPR2500-CM200-CM300 Install Guide 68009622001-A.pdf
    2 MB · Views: 87
OP
Forts

Forts

Prolific Contributor
CS Forums $upporter
Joined
Aug 6, 2012
Messages
857
Yeah, that's always an option. I did that with a remote mount 6550 in my work truck.
 
Mars

Mars

Prolific Contributor
CS Forums $upporter
Joined
Dec 21, 2011
Messages
4,993
Flashing via a direct connection to the brick is much more reliable than going through the control head, anyway. Might not be a bad compromise.
 
Status