• If posting about a radio issue: Include the HOST, DSP and UCM/secure firmware versions, flashcode and CPS version you're using along with the operating system info. This is critical information.

XPR series Quick Call II Question

Status
gmt0000

gmt0000

Contributing Member
CS Forums $upporter
Joined
Dec 30, 2014
Messages
28
Hello,
I'm setting up a XPR3500 for QCII decode on an analog channel (of course). I can't locate a place in the CPS to change the signaling type from "or" to "and" type. What I'm trying to accomplish is for the unit to remain muted until it receives the correct QCII, then unmute. So far, trying all the options (call alert, call alert w/ voice, sel call) the radio is open to all the traffic on the channel. It does decode the QCII. Any ideas?

Dale
 
n9upw

n9upw

Regular Member
Joined
Apr 8, 2015
Messages
8
Make sure you have your view set to expert. VIEW>EXPERT

It's located in the RX section of the channel page.
 
OP
gmt0000

gmt0000

Contributing Member
CS Forums $upporter
Joined
Dec 30, 2014
Messages
28
Yep, that was it! I am using a new computer with a fresh install of the CPS and forgot to change the view to expert..
 
Status