Communications Support Forums
I'm having a few intermittent issues with an XPR8400 repeater, but my other XPR8400 works like a champ. They are running different firmware versions so I'm currently chalking the issues up to firmware.
However, when I try to update the repeater from R02.40.01 to R02.40.20 it goes into a disabled state (expected I think) then the CPS software reports that it was "Error #2898 Unable to establish a connection with device. Please reset the device, reconnect it, and try again." Well I tried again about 5 or 6 times with the same result. Anyone have any advice to overcome this?
I'm using CPS 12.1
However, when I try to update the repeater from R02.40.01 to R02.40.20 it goes into a disabled state (expected I think) then the CPS software reports that it was "Error #2898 Unable to establish a connection with device. Please reset the device, reconnect it, and try again." Well I tried again about 5 or 6 times with the same result. Anyone have any advice to overcome this?
I'm using CPS 12.1