• If posting about a radio issue: Include the HOST, DSP and UCM/secure firmware versions, flashcode and CPS version you're using along with the operating system info. This is critical information.

XTS5000 beep on receive?

Status
A

AVFD

Not Registered
I have a UHF 380-470MHz XTS-5000 model III FPP and after about 2 seconds of receiving a transmission it lets off a single low pitched beep. I can only test it on analog since I do not have another UHF P25 radio to test it with. The radio is not on scan and for the life of me I cannot figure out how to make it go away. The info from the service menu is as follows if it would be of any assistance to any potential troubleshooters out there.

Host Version: R20.00.01
DSP Version: R19.50.00
Model Number: H18QDH9PW7AN
Flashcode: 5A0083-101B07-5
Tuning Version: R01.09.04
Proc Ver: BRAVO122

I also have a video of it as well, thanks in advance to anyone who can shed some light on this problem.
 
Mars

Mars

Prolific Contributor
CS Forums $upporter
Joined
Dec 21, 2011
Messages
4,993
It's called RX Clear Alert Tone, and it's the result of having Encrypted Tactical Inhibit enabled in the flashcode.

Someone, not knowing a thing about what they were doing, put the option into your radio.
 
OP
A

AVFD

Not Registered
I unchecked the "RX Clear Alert Tomes" option on the Advanced tab under Secure Configuration and that did the trick, thanks again for the help.
 
Status