Communications Support Forums
Hello,
I have recently come across an issue with a XTS5000 with an unusual issue regarding it's channel selector knob.
Regardless of what ZONE or CHANNEL you are currently on, when you move the channel selector knob, it chooses the appropriate channel number of the first zone only. This is instead of altering the channel in the current zone. For example, If you are in zone 3 and you select position 2 on the knob, it will choose channel 2 in zone 1
I have checked that the knob setting is set for channel (ie not 'zone', however the same issue occurs regardless). The knob itself works without fault.
The radio is a XTS5000 model 3 with FPP. (I understand that FPP can sometimes cause some interesting abnormalities).
HOST 14.00.01. DSP 14.00.00. Programmed with CPS 19.01.00. Flash: 5A9008-101F87-7
I am hopeful that this is a CPS programming issue buried deep, however, I have tried altering most settings without resolve. Is this a FW issue?
Many thanks in advance.
I have recently come across an issue with a XTS5000 with an unusual issue regarding it's channel selector knob.
Regardless of what ZONE or CHANNEL you are currently on, when you move the channel selector knob, it chooses the appropriate channel number of the first zone only. This is instead of altering the channel in the current zone. For example, If you are in zone 3 and you select position 2 on the knob, it will choose channel 2 in zone 1
I have checked that the knob setting is set for channel (ie not 'zone', however the same issue occurs regardless). The knob itself works without fault.
The radio is a XTS5000 model 3 with FPP. (I understand that FPP can sometimes cause some interesting abnormalities).
HOST 14.00.01. DSP 14.00.00. Programmed with CPS 19.01.00. Flash: 5A9008-101F87-7
I am hopeful that this is a CPS programming issue buried deep, however, I have tried altering most settings without resolve. Is this a FW issue?
Many thanks in advance.